LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> 5 GS, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Trunk Side Trim Removal/Installation

Trunk Side Trim Removal/Installation

  1. Disconnect the negative battery cable. (right-side only)
  2. Partially peel back the seaming welts.
  3. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Sub-trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
    3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
    5. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION .)
    6. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION .)
  4. Remove the screws A.
    G13728417Courtesy of MAZDA MOTORS CORP.
  5. Remove the service hole cover, then remove the screw B.
  6. Remove the bolt C, then remove the cargo net hook.
    Fig 1: Trunk Side Trim, Cargo Net Hook And Bolt C With Torque Specification
    G13728418Courtesy of MAZDA MOTORS CORP.
  7. Hold C-pillar trim with your hands and pull the trunk side trim in the direction of the arrow (1), (2), (3), (4) and remove hooks A and guides B.
    G13728419Courtesy of MAZDA MOTORS CORP.
  8. Pull the trunk side trim in the direction of arrow, while remove the clips C and pin D.
    G13728420Courtesy of MAZDA MOTORS CORP.
  9. Remove the trunk side trim.
  10. Install in the reverse order of removal.