LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2016 >> 6 Sport, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Power Systems >> Front Wiring Harness Protector Removal/Installation >> Front Wiring Harness Protector No. 2

Front Wiring Harness Protector No. 2

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)
  2. Remove the air cleaner assembly. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.5] .)
  3. Remove the battery and the battery tray. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5] .)
  4. While pressing the clip tabs of front wiring harness protector No. 2 in the direction of the arrows (1) shown in the figure, pull the clip of front wiring harness protector No. 2 in the direction of the arrow (2) shown in the figure to detach the clip tabs of front wiring harness protector No. 2 from the engine mount.
    Fig 1: Pressing Front Wiring Harness Protector No. 2 Clip Tabs
    G10988325Courtesy of MAZDA MOTORS CORP.
  5. Pull out the clip.
  6. Lift up the cap of front wiring harness protector No. 2 in the direction of the arrow (1) shown in the figure.
    Fig 2: Lifting Front Wiring Harness Protector No. 2 Cap
    G10988326Courtesy of MAZDA MOTORS CORP.
  7. Pull out the front wiring harness protector No. 2 from the stud bolt and set it aside as shown in the figure.
    Fig 3: Pulling Out Front Wiring Harness Protector No. 2 From Stud Bolt
    G10988327Courtesy of MAZDA MOTORS CORP.
  8. While pressing the clip tabs in the direction of the arrows (1) shown in the figure, push out the clip in the direction of the arrow (2) shown in the figure to detach the clip tabs from the front wiring harness protector No. 2.
    Fig 4: Pressing Front Wiring Harness Protector No. 2 Clip Tabs
    G10988328Courtesy of MAZDA MOTORS CORP.
  9. Pull out the clip.
  10. Insert a tape-wrapped flathead screwdriver into the gap between front wiring harness protector No. 2 and the tab shown in the figure.

    FRONT WIRING HARNESS PROTECTOR No. 2 

    Fig 5: Inserting Tape Wrapped Flathead Screwdriver Into Gap Between Front Wiring Harness Protector No. 2 And Tab
    G10988329Courtesy of MAZDA MOTORS CORP.
  11. While lifting up the hook in the direction of the arrow (1) shown in the figure using a flathead screwdriver, pull the hook in the direction of the arrows (2) shown in the figure to detach the tab from the hook.
    Fig 6: Lifting Front Wiring Harness Protector No. 2 Hook Using Flathead Screwdriver
    G10988330Courtesy of MAZDA MOTORS CORP.
  12. Detach all the tabs from hooks and remove the front wiring harness protector No. 2.
  13. Install in the reverse order of removal.