LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> MX-5 Miata Club, Standard Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> On-Board Diagnostic [Dynamic Stability Control System] >> DTC C1306 [Dynamic Stability Control (DSC)] >> Notes

DTC C1306 [Dynamic Stability Control (DSC)]: Notes

NOTE:
  • The initialization value of the steering angle sensor is stored using the battery power supply. Therefore, the battery power supply of the steering angle sensor is cut and the stored initialization value is cleared when any of the following items are performed. DTC C1306 is stored in the memory.
    • Negative battery cable disconnection
    • Steering angle sensor connector disconnection
    • Fuse (ROOM 15A) removal
    • Wiring harness disconnection between battery and steering angle sensor connector
DTC C1306 DETECTION CONDITION AND POSSIBLE CAUSE

DTC C1306 Steering angle sensor (abnormal initialization) system
DETECTION CONDITION 
  • Signal which indicates that the initialization has not been performed is continuously received from the steering angle sensor for 100 ms. 
POSSIBLE CAUSE 
  • The initialization procedure for the steering angle sensor has not been performed.
  • The negative battery cable connector was disconnected previously.
  • The steering angle sensor connector was disconnected previously.
  • The fuse (ROOM 15A) was removed previously.
  • The wiring harness between battery-steering angle sensor connector is disconnected.
  • Steering angle sensor malfunction