LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 6 i Touring Plus >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting [Engine Control System MZR 2.5] >> No.9 Fast Idle/Runs On >> Diagnostic Procedure

Diagnostic Procedure

STEP INSPECTION RESULTS ACTION
1 INSPECT COOLING SYSTEM FOR MALFUNCTION 
  • Access the PCM PID ECT using the M-MDS.

    (See ON-BOARD DIAGNOSTIC TEST .)

  • Start and warm up the engine to normal operating temperature.
  • Is the ECT PID between 82-112 °C {180-233 °F}  ?
Yes Go to the next step.
No ECT PID is higher than 112 °C {233 °F}  :

ECT PID is less than 82 °C {180 °F}  :
2 VERIFY PCM DTC 
Yes Go to the appropriate DTC inspection.
(See DTC TABLE .)
No Go to the next step.
3 VERIFY CURRENT INPUT SIGNAL STATUS 
  • Access and monitor the following PCM PIDs using the M-MDS.

    (See ON-BOARD DIAGNOSTIC TEST .)

    • AC_REQ
    • COLP
    • CPP (MTX)
    • CPP/PNP (MTX)
    • PSP
    • TR (ATX)
  • Are all PID values normal?

    (See PCM INSPECTION .)

Yes Go to the next step.
No AC_REQ PID is not specified:

COLP PID is not specified: 

CPP PID is not specified: 

CPP/PNP PID: 

PSP PID: 

TR PID: 

Repair or replace the malfunctioning part according to the inspection results.
4 INSPECT INTAKE AIR SYSTEM FOR AIR LEAKAGE 
  • Is there air leakage felt or heard at the intake air system components while racing the engine to higher speed?
Yes Repair or replace the malfunctioning part according to the inspection results.
No Inspect the following:

Repair or replace the malfunctioning part according to the inspection results.
5
  • Verify test results.
    • If normal, return to diagnostic index to service any additional symptoms.

      (See SYMPTOM DIAGNOSTIC INDEX .)

    • If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis.
      • If vehicle is repaired, troubleshooting completed.
      • If vehicle is not repaired or additional diagnostic information is not available, reprogram the PCM if a later calibration is available. Retest.