LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 6 i Touring Plus >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting [Engine Control System MZR 2.5] >> Intermittent Concern Troubleshooting >> Inspection Method for Switch Connectors or Wiring Harnesses

Inspection Method for Switch Connectors or Wiring Harnesses

  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition to ON (engine off).
    NOTE:
    • If the engine starts and runs, perform the following steps during idle.
  3. Access PIDs for the switch you are inspecting.
  4. Turn the switch on manually.
  5. Slightly shake each connector or wiring harness vertically and horizontally while monitoring the PID.
    • If PID value is unstable, inspect for poor connection.
      Fig 1: Inspecting Switch Connectors Or Wiring Harnesses
      G08140216Courtesy of MAZDA MOTORS CORP.