Leakage Inspection: Notes
- Do not try to stop the fluid leak by increasing the torque beyond specifications. This may cause damage to the case threads.
Leakage at the main transaxle control cover to transaxle often can be stopped by tightening the attaching bolts to 14 N.m {1.4 kgf.m, 124 in.lbf}. If necessary, remove the main control cover and inspect for damage. See MAIN CONTROL COVER REMOVAL/INSTALLATION .
Check the fluid filler tube connection at the transaxle case. If leakage is found, install a new grommet.
Check transaxle fluid tubes and fittings between the transaxle and the cooler in the radiator tank for wear or damage. If leakage cannot be stopped by tightening a tube nut, install new parts. When transaxle fluid is found leaking between the case and the transaxle fluid tube fitting, check for a missing or damaged O-ring, then tighten the fitting to torque specification. If the leak continues, install a new transaxle fluid cooler tube fitting and tighten to the correct torque specification. The same procedure should be followed for transaxle fluid leaks between the radiator cooler and the transaxle fluid cooler tube fittings. See AUTOMATIC TRANSAXLE COOLING - 2.5L AND 3.0L -- TRIBUTE .
Check the engine coolant in the radiator. If transaxle fluid is present in the coolant, the cooler in the radiator is probably leaking. The cooler can be further checked for leaks by disconnecting the transaxle fluid cooler tubes from the cooler fittings and applying no more than 345 kPa (50 psi) air pressure to the fittings. Remove the coolant recovery cap to relieve the pressure buildup at the exterior of the transaxle fluid cooler tank. If the cooler is leaking and/or will not hold pressure, install a new cooler.
If leakage is found at the transaxle range selector lever, install a new seal.
If transmission fluid leakage is found at the transaxle internal harness connector, install a new O-ring.