LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> Tribute i Touring, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Hydraulic Control Unit (HCU) Removal/Installation >> Removal/Installation

Hydraulic Control Unit (HCU) Removal/Installation: Removal/Installation

All vehicles 

  1. Remove the air cleaner and the air cleaner outlet pipe. See AIR CLEANER OUTLET PIPE - 2.5L REMOVAL/INSTALLATION or AIR CLEANER OUTLET PIPE - 3.0L (4V) REMOVAL/INSTALLATION .
  2. Disconnect the master cylinder brake tube fittings from the HCU.
    • To install, tighten to 23 N.m {2.3 kgf.m, 17 ft.lbf}.

    Vehicles with 3.0L engine 

  3. Disconnect the master cylinder brake tube fittings from the master cylinder and remove the brake tubes.
    • To install, tighten to 23 N.m {2.3 kgf.m, 17 ft.lbf}.

      All vehicles 

  4. Disconnect the front brake tube fittings from the HCU.
    • To install, tighten to 15 N.m {1.5 kgf.m, 133 in.lbf}.
      NOTE:
      • The brake tubes must be installed in the same location as removed.
  5. Disconnect the rear brake tube fittings from the jumper tubes.
    • To install, tighten to 15 N.m {1.5 kgf.m, 133 in.lbf}.
  6. Disconnect the electrical connector by rotating the protective cover.
    Fig 1: Disconnecting Electrical Connector
    G05460061Courtesy of MAZDA MOTORS CORP.
  7. Remove the 3 HCU bracket-to-frame bolts and remove the HCU.
    • To install, tighten to 20 N.m {2.0 kgf.m, 177 in.lbf}.
  8. To install, reverse the removal procedure.