LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Touring, 1.5 Z, Standard >> Repair and Diagnosis >> Transmission >> Manual Transaxle Clutch [F35M-R] >> Flywheel Inspection

Flywheel Inspection

  1. Remove the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION .)
    NOTE:
    • Correct slight scratches and discoloration using sandpaper.
    • Inspect the runout of the surface that contacts the clutch disc with the flywheel installed to the crankshaft.
  2. Inspect the surface that contacts the clutch disc for scratches, nicks, and discoloration.
    Fig 1: Correcting Slight Scratches And Discoloration Using Sandpaper
    G06941172Courtesy of MAZDA MOTORS CORP.
  3. Inspect the ring gear teeth for damage and wear.
  4. Install the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION .)
  5. Measure the runout of the surface that contacts the clutch disc using a dial gauge.

    Flywheel maximum runout 0.05 mm {0.002 in} 

Fig 2: Measuring Clutch Disc Contact Surface Runout Using Dial Gauge
G06941173Courtesy of MAZDA MOTORS CORP.