Fuel Pump Cap Installation Note
NOTE:
- The fuel pump unit will rotate and cannot be secured in the specified position if there is any fuel on the gasket. Thoroughly wipe away all fuel from the gasket.
- Marks are provided on the fuel pump unit and fuel tank for correct installation of the fuel pump unit.
- Align the fuel tank mark (No. 1) with the fuel pump unit mark as shown in the figure.
- Align the threading start point of the fuel pump cap with the fuel tank mark (No. 2) as shown in the figure.
- While keeping the fuel pump unit from rising up, tighten the fuel pump cap by hand 220-260°
clockwise.CAUTION:
- The cap could be damaged if the SST is used with any play between the cap and the SST. Securely install the SST so that there is no gap between the SST tabs and the side of the cap.
- Set the SST as shown in the figure.
- Using the SST, tighten the fuel pump cap with 360° without shifting the fuel tank mark (No. 1) and fuel pump unit alignment marks.
NOTE:
- The total rotation angle is 580-620° if the 220-260° from Step 3 is included.
- If the specified tightening torque cannot be obtained, replace the fuel pump cap and gasket.
- If the specified tightening torque cannot be obtained after replacement of the fuel pump cap and gasket, replace the fuel tank.