LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> CX-7 AWD L4-2.3L Turbo >> Repair and Diagnosis >> Powertrain Management >> Emission Control Systems >> Evaporative Emissions System >> Leak Detection Pump >> Service and Repair

Leak Detection Pump: Service and Repair




EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK DETECTION PUMP REMOVAL/INSTALLATION [L3 WITH TC]

2WD

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.










3. Install in the reverse order of removal.

AWD

1. Disconnect the negative battery cable.

NOTE:
- Because the AWD EVAP system leak detection pump is installed surrounded by the rear differential, there is insufficient space for removing the pump from the vehicle. Therefore, it is necessary to remove the EVAP system leak detection pump and bracket separately from the vehicle.

2. Remove in the order indicated in the table.










3. Install in the reverse order of removal.

EVAP system leak detection pump and bracket removal note

NOTE:
- Because the AWD EVAP system leak detection pump is installed surrounded by the rear differential, there is insufficient space for removing the pump from the vehicle. Therefore, it is necessary to remove the EVAP system leak detection pump and bracket separately from the vehicle.

1. Reverse the EVAP system leak detection pump and bracket.






2. Remove the installation screws from the EVAP system leak detection pump.






3. Remove the EVAP system leak detection pump.

4. Remove the EVAP system leak detection pump bracket.