LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> 5 Touring, 2.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Cooling System (L3)) >> Fan Control Module Inspection [L3]

Fan Control Module Inspection [L3]

WARNING: This page is about a different variant/trim than selected.
  1. Start and warm up the engine.
  2. Monitor the engine coolant temperature with the M-MDS.
  3. Measure the voltage between fan control module connector (2 terminals) terminals 2A and 2B from the harness side as shown in the table.
    Fig 1: Identifying Fan Control Module Connector Terminals
    G05543143
    ENGINE COOLANT TEMPERATURE AND VOLTAGE SPECIFICATION

    Inspection Result
    Condition A/C Engine coolant temp.
    IG SW ON or idling OFF 95 °C {203 °F} or less 0 V
    Idling ON(1) 95 °C {203 °F} or less 8.9-10.3 V
    Idling OFF 100 °C {212 °F} or more 4.1-14.6 V
    (1) Refrigerant pressure switch (middle) is on.
    • If not within the specification, inspect the input signals from the following parts.
      • Crankshaft Position (CKP) sensor
      • Engine Coolant Temperature (ECT) sensor
      • Throttle Position (TP) sensor
      • Refrigerant pressure switch (middle)
  4. If all the above parts are normal, replace the fan control module.