LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Backrest Front - 60 Percent Bench Disassembly / Assembly >> Disassembly

Seat Backrest Front - 60 Percent Bench Disassembly / Assembly: Disassembly

WARNING:
  • The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
WARNING:
  • To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
  • If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
NOTE:
  • The air bag warning lamp illuminates when the restraint control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
NOTE:
  • The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Depower the SRS. See DEPOWERING AND REPOWERING , .
  2. Remove the affected seat. See SEAT FRONT REMOVAL / INSTALLATION ,
  3. Remove the 60 percent armrest. See SEAT ARMREST FRONT - 60 PERCENT BENCH REMOVAL / INSTALLATION , .
  4. Remove the 60 percent seat backrest assembly. See SEAT BACKREST FRONT - 60 PERCENT BENCH REMOVAL / INSTALLATION , .
    Fig 1: Locating Backrest J-Clip
    G04931150
  5. Release the backrest J-clip.
    Fig 2: Separating Seat Back Trim Cover
    G04931151
    CAUTION:
    • Use care when separating the seat back trim cover from the hook and loop strips or the hook and loop strips may be torn from the seat back foam.
  6. Invert the backrest material and release the hook and loop strips.
    Fig 3: Locating Hog Rings
    G04931152
  7. Remove all the hog rings and remove the backrest trim cover from the backrest foam pad.
    Fig 4: Lifting Lower End Of Backrest Foam Pad Off Backrest Frame
    G04931153
  8. Lift the lower end of the backrest foam pad off the backrest frame.
    Fig 5: Sliding Backrest Frame Down
    G04931154
  9. Slide the backrest frame down and out of the backrest foam pad headrest pocket.