LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 3 i, 2.0 F, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic (Engine Control System LF, L3) (2 Of 5) >> DTC P0038 >> California Emission Regulation Applicable Model >> Notes

California Emission Regulation Applicable Model: Notes

DTC P0038 (LF, L3) DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0038 Middle HO2S heater circuit high input
DETECTION CONDITION 
  • The PCM monitors the middle HO2S heater control voltage when the PCM turns the middle HO2S heater on. If the control voltage is less than 57%  of the battery voltage, the PCM determines that the middle HO2S heater control circuit voltage is high.

Diagnostic support note 
  • This is a continuous monitor (HO2S heater).
  • The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Middle HO2S heater malfunction
  • Connector or terminal malfunction
  • Open circuit in wiring harness between main relay and middle HO2S terminal C
  • Short to ground in wiring harness between main relay and middle HO2S terminal C
  • Open circuit in wiring harness between middle HO2S terminal D and PCM terminal 2BF
  • Short to ground in wiring harness between middle HO2S terminal D and PCM terminal 2BF
  • PCM malfunction
G04954272Courtesy of MAZDA MOTORS CORP.