LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 3 i, 2.0 F, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> On-Board Diagnostic (Dynamic Stability Control) >> DTC C1095 [Dynamic Stability Control (DSC)] >> Notes

DTC C1095 [Dynamic Stability Control (DSC)]: Notes

DTC C1095 DETECTION CONDITION AND POSSIBLE CAUSE

DTC C1095 Pump motor, motor relay
DETECTION CONDITION 
  • DSC motor monitor signal does not correspond to DSC HU/CM OFF signal.
  • DSC motor monitor signal does not correspond to DSC HU/CM ON signal.
  • DSC motor monitor ON signal is not input within specified time limit when motor signal is switched from ON to OFF by DSC HU/CM.
POSSIBLE CAUSE 
  • ABS 1 30A fuse malfunction
  • Open circuit or short to ground in the wiring harness between DSC HU/CM terminal AT and battery
  • Open circuit in the wiring harness between DSC HU/CM terminal B and body ground
  • Open or short circuit in the DSC HU/CM internal motor relay, or stuck motor relay
  • Open or short circuit in the DSC HU/CM internal pump motor, or frozen pump motor
  • Poor connection at connectors (female terminal)
G04955619Courtesy of MAZDA MOTORS CORP.