LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> Tribute i, 4WD, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Idle Air Control (IAC) Valve - 2.3L >> Removal and Installation

Removal and Installation

  1. Remove the air cleaner outlet tube. See AIR CLEANER OUTLET PIPE -- 2.3L .
  2. Remove the upper snow shield.
    • Remove the upper snow shield-to-intake manifold screw.
    • Remove the upper snow shield-to-intake manifold pin-type retainer.
  3. Remove the lower snow shield.
    • Remove the lower snow shield-to-intake manifold screws (2 req'd).
  4. Disconnect the idle air control (IAC) valve electrical connector.
    Fig 1: Disconnecting Idle Air Control (IAC) Valve Electrical Connector
    G03725023Courtesy of MAZDA MOTORS CORP.
  5. Remove the two bolts and the IAC valve.
    • Discard the gasket.
  6. To install, reverse the removal procedure.
    • Install a new gasket.