LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B4000 Base, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Differential >> Differential Case Front Disassembly/Assembly >> Disassembly Note

Disassembly Note

  1. Remove differential case from the front drive axle housing; see AXLE AND DIFFERENTIAL FRONT DISASSEMBLY/ASSEMBLY  .
  2. Remove the ring gear.
    1. Remove the eight bolts.
    2. Use a drift that will bottom out in the ring gear bolt holes to separate the ring gear from the differential case.
    Fig 1: Removing Ring Gear
    G01923879Courtesy of MAZDA MOTORS CORP.
  3. Drive out the differential pinion shaft roll pin from the differential case.
    Fig 2: Removing Differential Pinion Shaft Roll Pin From Differential Case
    G01923880Courtesy of MAZDA MOTORS CORP.
  4. Remove the differential pinion shaft.
    Fig 3: Removing Differential Pinion Shaft
    G01923881Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Differential side gears may fall out after removing the differential pinion gears.
  5. Rotate the differential pinion gears to the differential case window and remove them and the differential pinon thrust washers.
    Fig 4: Removing Differential Pinion Gears And Differential Pinon Thrust Washers
    G01923882Courtesy of MAZDA MOTORS CORP.
  6. Remove the differential side gears and the differential side gear thrust washers.
    Fig 5: Removing Differential Side Gears And Differential Side Gear Thrust Washers
    G01923883Courtesy of MAZDA MOTORS CORP.
  7. Assemble Pinion and Carrier Bearing Puller ST  49 UN01 029.
    Fig 6: Assembling Pinion And Carrier Bearing Puller
    G01923884Courtesy of MAZDA MOTORS CORP.
  8. Position Pinion and Carrier Bearing Puller ST  49 UN01 029.
    Fig 7: Positioning Pinion And Carrier Bearing Puller
    G01923885Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • The differential bearings must be installed on the same side they were removed from.
  9. Use Pinion and Carrier Bearing Puller ST  49 UN01 029 to remove the differential bearing.
    • Repeat the procedure for the other side.
    Fig 8: Removing Differential Bearing
    G01923886Courtesy of MAZDA MOTORS CORP.