4x2 Removal
- Turn the wheel to the straight-ahead position and turn the ignition switch to the OFF position.
- Remove the front wheel and tire assemblies; see WHEEL & TIRE INSPECTION/ADJUSTMENT
.
- Remove the fluid cooler; see POWER STEERING FLUID COOLER REMOVAL/INSTALLATION
.
- Remove and discard the cotter pins and nuts at the tie rod ends.
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- Do not damage the tie-rod boot when installing the special tool.
NOTE:
- Remove the adapter from the ball end of the special tool. Apply a small amount of grease to the tie-rod end stud and the ball of the special tool.
- Using the special tool, separate the tie rod ends from the wheel knuckles.
CAUTION:
- Do not allow the intermediate shaft to rotate while it is disconnected from the steering gear or damage to the clock-spring can result. If there is evidence that the intermediate shaft has rotated, the clockspring must be removed and re-centered. For additional information see AIR BAG SLIDING CONTACT REMOVAL/INSTALLATION
.
- Remove the pinch bolt and detach the intermediate shaft from the gear.
- Discard the bolt.
Courtesy of MAZDA MOTORS CORP.
- Remove the nut and disconnect the lines.
Courtesy of MAZDA MOTORS CORP.
- Plug or cap the power steering return hose, power steering pressure hose and the steering gear ports to prevent entry of dirt.
CAUTION:
- Hold the tops of the steering gear to crossmember stud bolts to avoid damaging the steering gear fluid transfer tubes.
- Remove the nuts.
Courtesy of MAZDA MOTORS CORP.
- Remove the mounting stud, nut, washer and stop assemblies.
Courtesy of MAZDA MOTORS CORP.
- Remove the steering gear.