LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Backrest Front - Bucket And 40 Percent Bench Removal/Installation >> Removal Note: >> Installation Note:

Installation Note:

WARNING:
  • To reduce the risk of serious personal injury, read and follow warnings, cautions, and notes at the beginning of the removal procedure.

All Vehicles 

  1. Position the front seat backrest.
    Fig 1: Installing Pivot Bolt
    G01925890Courtesy of MAZDA MOTORS CORP.
  2. Install the pivot bolt.
    Fig 2: Installing Pivot Bolt
    G01925891Courtesy of MAZDA MOTORS CORP.
  3. Install the pivot bolt.
    Fig 3: Installing Recliner Bolt
    G01925892Courtesy of MAZDA MOTORS CORP.
  4. Install the two recliner bolts (one on each side).

    Vehicles With Manual Lumbar 

  5. Route the lumbar adjustment cable as noted during removal.
    Fig 4: Connecting Lumbar Support Adjuster And Lumbar Adjustment Cable
    G01925893Courtesy of MAZDA MOTORS CORP.
  6. Connect the lumbar support adjuster and the lumbar adjustment cable.
  7. Install the lumbar support adjuster and two screws.
    Fig 5: Installing Lumbar Adjustment Knob
    G01925894Courtesy of MAZDA MOTORS CORP.
  8. Install the lumbar adjustment knob.

    Vehicles Without Safety Belt Buckle Pretensioners 

    WARNING:
    • To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat removal and installation procedure.
  9. Install the 60 percent bench seat. See SEAT FRONT - 60/40 SPLIT BENCH DISASSEMBLY/ASSEMBLY  .

    Vehicles With Safety Belt Buckle Pretensioners 

  10. Restore the vehicle to operating condition.
    WARNING:
    • To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat removal and installation procedure.
    1. Remove the 60 percent bench seat. See SEAT FRONT - 60/40 SPLIT BENCH DISASSEMBLY/ASSEMBLY  .
      WARNING:
      • To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.

      To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).

    2. Disconnect the negative battery cable.
      WARNING:
      • To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the supplemental restraint system (SRS) deactivation/reactivation procedure.
    3. Reactivate the supplemental restraint system (SRS). See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION AND ACTIVATION  .
    4. Connect the negative battery cable.
    5. With all restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See AIR BAG SYSTEM DIAGNOSTICS .

    All Vehicles 

  11. Check the active restraint system for correct operation. See AIR BAG SYSTEM DIAGNOSTICS .