LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Armrest Front - 60 Percent Bench Removal/Installation >> Removal Note:

Removal Note:

WARNING:
  • Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING:
  • After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is irritating to the skin. Wash your hands with soap and water afterwards.
WARNING:
  • Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.

Vehicles With Safety Belt Buckle Pretensioners 

  1. Prepare the vehicle for seat armrest removal.
    WARNING:
    • To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.

    To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).

    1. Disconnect the negative battery cable.
      WARNING:
      • To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the supplemental restraint system (SRS) deactivation/reactivation procedure.
  2. Deactivate the supplemental restraint system (SRS). See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION AND ACTIVATION  .
    WARNING:
    • To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat removal and installation procedure.
  3. Remove the 60 percent bench seat. See SEAT BACKREST FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATION 

    Vehicles Without Safety Belt Buckle Pretensioners 

    WARNING:
    • To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat removal and installation procedure.
  4. Remove the 60 percent bench seat. See SEAT BACKREST FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATION 

    All vehicles 

    Fig 1: Removing Bolts And Center Child Safety Seat Tether Anchor
    G01925903Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolts and the center child safety seat tether anchor.
  6. Detach the hook and loop fastener located behind the center child safety seat tether anchor.
    Fig 2: Detaching Hook And Loop Fastener Located Behind Center Child Safety Seat Tether Anchor
    G01925904Courtesy of MAZDA MOTORS CORP.
  7. Detach the hook and loop fastener.
    Fig 3: Detaching Hook And Loop Fastener
    G01925905Courtesy of MAZDA MOTORS CORP.
  8. Remove the bolt.
  9. Remove the seat armrest.
    Fig 4: Removing Seat Armrest
    G01925906Courtesy of MAZDA MOTORS CORP.
  10. Remove the armrest bracket shrouds.
    Fig 5: Removing Bolt And Armrest Bracket
    G01925907Courtesy of MAZDA MOTORS CORP.
  11. Remove the two bolts and the armrest bracket.