LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1997 >> MX-6 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments - 2.0L >> Ignition Timing >> MX-6 2.0L A/T

MX-6 2.0L A/T

  1. Connect New Generation Star (NGS) scan tool to data link connector 2 located under left side of instrument panel, right of steering column. See Fig 1 . Connect a jumper wire between terminals TEN and GND at data link connector in engine compartment. See Fig 2 . Ensure idle speed is correct. See IDLE SPEED & MIXTURE.
  2. Connect timing light to engine and check timing. See Fig 3 . See IGNITION TIMING SPECIFICATIONS  table. If ignition timing is not within specification, check distributor installation. Distributor cannot be rotated to adjust ignition timing.
IGNITION TIMING SPECIFICATIONS

Application M/T (1) A/T
MX-6 2.0L (2) 11-13 @ 650-750 11-13 @ 650-750
(1) Place automatic transmission in Park.
(2) Connect a jumper wire between terminals TEN and GND of data link connector. See Fig 2 .
Fig 1: Locating Data Link Connector 2 (Typical)
G95G32280Courtesy of MAZDA MOTORS CORP.
Fig 2: Identifying Data Link Connector Terminals
G97I06647Courtesy of MAZDA MOTORS CORP.
Fig 3: Locating Ignition Timing Marks (Typical)
G95G31464Courtesy of MAZDA MOTORS CORP.