LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1995 >> B3000 Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - Four Wheel >> Circuit Tests >> Test NN: Rear Axle Speed Sensor

Test NN: Rear Axle Speed Sensor

  1. DTC 1229, 1260 Or 1237

    Turn ignition off. Install Breakout Box (49-UN01-058) with proper overlay. Raise and support vehicle. Check sensor rotor for damage. Check sensor mounting for looseness. Repair as necessary. If components are okay, go to next step.
  2. Check Speed Sensor Output

    Shift transfer case into 2WD mode. Start engine and allow wheels to rotate at engine idle speed. Measure and record frequency between breakout box pins No. 21 and 22. Change meter to A/C mV setting. Measure and record voltage output between breakout box pins No. 21 and 22. Ensure both measurements are recorded at same wheel speed. Determine sensor output in mV/Hz, by dividing A/C voltage reading by frequency reading. If sensor output is more than 6.0 mV/Hz, output at control module indicates air gap and sensor signal are okay. Go to step 4). If sensor output is less than specified, sensor output at control module is insufficient. Go to next step.
  3. Check Output At Speed Sensor

    Disconnect sensor connector at rear differential. Repeat step 2), but measure and record frequency between sensor terminals. Change meter to A/C mV setting. Measure and record voltage output between sensor connector terminals. Ensure both readings are measured at same wheel speed. Determine sensor output in mV/Hz, by dividing A/C voltage reading by frequency reading. If sensor output is more than 6.0 mV/Hz, output indicates air gap and sensor signal are okay. Go to next step. If sensor output is less than specified, replace sensor and recheck sensor output.
  4. Check For Wiring Intermittents

    If all previous steps have been performed, and problem still exists, condition may be wiring related. Closely check Red/Pink wire and Light Green/Black wire between sensor and control module. See INTERMITTENT DIAGNOSIS PROCEDURE  . Repair wiring as necessary. If wiring is okay and condition still exists after intermittent diagnosis procedure is performed, go to next step. If problem is corrected, test drive vehicle.
  5. Check If Steps Have Been Completed

    If this step is not completed, replacement of any system component without being instructed to do so may not correct system fault. This step requires that a valid code be present, completion of all prior steps, and affected wiring integrity verified. If all previous steps have not been completed, return to last test step completed, and continue testing. If all prior steps have been completed, replace rear axle speed sensor and go to next step. If condition still exists after completing next step, replace control module and repeat next step.
  6. Speed Sensor Output Drive Test

    Remove breakout box and adapter. Connect all components. Clear fault codes and cycle ignition key. Drive vehicle and complete at least one hard left and right turn. Travel over a rough road at steady speed. Perform one hard acceleration from a stop. At completion of test drive, check for fault codes. If SYSTEM PASS is set, repair is complete. If code other than DTC 1229, 1237 or 1260 is set, perform appropriate circuit test. If DTC 1229, 1237 or 1260 still exists and control module has been replaced, go to next step.
  7. Possible Conditions Not Checked

    This step assumes that wiring integrity has been verified and rear axle speed sensor and control module have been replaced. The following is time consuming and should be performed only after all previous possibilities have been exhausted. Inspect Red/Pink wire and Light Green/Black wire between rear axle speed sensor and control module. Check for chafing or any other damage that could cause an open or shorted condition. Repair wiring as necessary. If wiring is okay, inspect for excessive axle vibration, especially over rough road. Ensure rear axle is operating correctly. Repair as necessary. If code still exists, repeat step 5).