Test No. 4
- Turn ignition off. Unplug connector from servo. Turn ignition on. With brakes released, test for battery voltage between servo harness connector terminals No. 9 (Black/Yellow wire) and No. 10 (Pink/Orange wire). If battery voltage exists, go to next step. If battery voltage does not exist, go to TEST NO. 1.
- With brakes applied, test for battery voltage between servo harness connector terminals No. 9 (Black/Yellow wire) and No. 10 (Pink/Orange wire). If voltage is less than 0.5 volt, go to next step. If voltage is 0.5 volt or more, replace deactivator switch.
- With brakes applied, test for battery voltage between servo harness connector terminals No. 4 (Tan/Light Blue wire) and No. 10 (Pink/Orange wire). If battery voltage exists, go to next step. If battery voltage does not exist, repair stoplight circuit as necessary.
- Disengage cable from servo. Inspect for broken cable by pulling end of cable and observing throttle movement. Replace cable if necessary. If cable is okay, temporarily substitute known good servo, then retest.