LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> B2200 Base, 2D Pickup, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - CARBURETED >> Evaporative Emission Control >> Purge Solenoid Valve Control Signal Test

Purge Solenoid Valve Control Signal Test

  1. Warm engine to operating temperature and run at idle. Connect voltmeter between Yellow/Red wire terminal of purge solenoid valve and ground. See Fig 1 . Connect tachometer to engine.
  2. Increase engine speed and verify voltmeter indicates zero volts at more than 1400 RPM. If it does not, check coolant thermosensor and ECU terminal 1C. See J - PIN VOLTAGES CHARTS and SENSOR RANGE CHARTS articles. Replace ECU if necessary.
  3. Disconnect vacuum sensor hose. Connect vacuum pump to sensor. Apply vacuum. Verify voltmeter indicates approximately 12 volts at more than 7.9 in. Hg. If it does not, check coolant thermosensor, vacuum sensor and ECU terminals 1C and 1E. See J - PIN VOLTAGES CHARTS and SENSOR RANGE CHARTS articles.
Fig 1: Testing Solenoid Valve Control Signal
G117753Courtesy of MAZDA MOTORS CORP.