LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> B2200 Base, 2D Pickup, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - CARBURETED >> Emission Systems & Sub-Systems >> Air Control Solenoid Valve (ACV) Test

Air Control Solenoid Valve (ACV) Test

  1. Warm engine to operating temperature. Connect a jumper wire between coolant temperature switch terminals. Connect voltmeter between Yellow wire terminal of ACV solenoid valve and ground. See Fig 1 . Verify voltmeter indicates zero volts at 1500 RPM or higher. If voltage is not as indicated, check ECU terminal 2J. See PIN VOLTAGE CHART S and SENSOR RANGE CHARTS articles.
  2. Remove air control solenoid valve. Connect hoses to valve ports. Blow through hose "A" and verify air comes out of valve air filter. Apply battery power and ground to valve with jumper wires. Blow air through hose "A" and verify air does come out of port "B". See Fig 2 . Replace ACV solenoid valve if necessary.
    Fig 1: Testing Air Control Solenoid Valve Signal
    G117746Courtesy of MAZDA MOTORS CORP.
    Fig 2: Testing Air Control Solenoid Valve
    G117747Courtesy of MAZDA MOTORS CORP.