LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1980 >> RX-7 GS, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Ignition System >> MITSUBISHI Electronic Ignition Systems - Rotary Engine >> Overhaul >> Disassembly

MITSUBISHI Electronic Ignition Systems - Rotary Engine: Overhaul: Disassembly

  1. Remove distributor cap, rotor and seal cover. See Figure. Remove clips holding vacuum diaphragm links. Remove screws attaching vacuum control units to distributor housing. Remove vacuum control units and condenser.
  2. Remove reluctor (signal rotor) shaft attaching screw from end of shaft. Remove pick-up coil base bearing attaching screws. Remove reluctor, reluctor shaft, pick-up coils and coil base bearing assembly from top of distributor drive shaft.
  3. Remove reluctor from reluctor shaft, using suitable puller. Remove spring pin. Remove governors by removing springs. Drive lock pin out of driven gear, using a small drift. Remove gear and washers. Remove drive shaft through top of distributor housing.