LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1972 >> R100 Standard Trans >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch Assembly

Clutch Assembly

  1. Disconnect battery ground wire. From inside driver compartment, remove console assembly (if equipped) and pull up boot on shift lever.
  2. Remove bolts from gear shift lever cover plate. Remove plate, dust boots and bushing with gear shift lever. Disconnect wires at starter and back-up light switch. Remove starter.
  3. Drain transmission oil and disconnect speedometer cable. Remove clutch fork return spring. Remove nuts from slave cylinder and remove cylinder with push rod.
  4. On 1200 models, disconnect parking brake return spring and cable from lever. Disconnect exhaust pipe from manifold and push out of way.
  5. Disconnect drive shaft from differential and pull from transmission. Support transmission with a jack and remove rear crossmember.
  6. Remove bolts securing transmission to engine. Pull transmission to rear to remove. Install a suitable flywheel holder and remove clutch assembly.
  7. To install, reverse removal procedure. Use a suitable pilot shaft (49 0813 310) to align clutch. Tighten all bolts and nuts to specifications.