LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1971 >> RX-2 Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> MAZDA Engines - Rotary Piston Engine >> Engine Assembly >> Distributor Installation

Distributor Installation

  1. Rotate engine in correct rotation direction until first mark on pulley aligns with pointer on front cover. This positions front rotor at TDC of compression stroke.
    Fig 1: Positioning Engine At TDC
    G09325871Courtesy of MAZDA MOTORS CORP.
  2. Install socket for leading distributor through gasket in front of cover and position so that groove on upper side of drive shaft is 17° to right of center line of engine (see Fig 2).
  3. Install socket for trailing distributor through gasket in front cover so that groove on upper side of drive shaft is 34° to right side of center line of engine (see Fig 2).
    Fig 2: Distributor Socket Installation
    G09325872Courtesy of MAZDA MOTORS CORP.
  4. Install distributors in front cover noting "T" and "L" marks on vacuum advance units of distributor. This denotes trailing and leading distributors. Align key of distributor with groove in drive shaft.
  5. Rotate distributors in direction shown in illustration until contact points just start to open. Tighten lockplates, securing both distributors. Install remaining components on engine by reversing removal procedure.
    Fig 3: Distributor Rotation Direction
    G09325873Courtesy of MAZDA MOTORS CORP.