LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2014 >> Navigator Base, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Cooling System >> Diagnosis And Testing >> Transmission Cooling >> Inspection and Verification

Inspection and Verification

NOTE: When internal wear or damage occurs in the transmission, metal particles and clutch plate material can travel into the torque converter, the transmission fluid cooler tubes, the in-tank transmission fluid cooler and the auxiliary transmission fluid cooler, if equipped. These contaminants are a major cause of recurring transmission concerns. To prevent future concerns, remove these contaminants from the cooling system before placing the transmission back into use. Refer to TRANSMISSION FLUID COOLER BACKFLUSHING AND CLEANING .
  1. Visually inspect for obvious signs of mechanical damage, incorrect component installation and system leaks. Repair as necessary.
    • Install a new or remanufactured radiator when transmission fluid is found leaking from the in-tank transmission fluid cooler. Refer to Removal and Installation .
    • Install a new O-ring when transmission fluid is found leaking between the radiator transmission fluid cooler and the transmission fluid cooler fitting (not the cooler tube into the fitting). Refer to the COMPONENT TEST  in this article.
    • Install a new auxiliary transmission fluid cooler if there is leakage from the transmission fluid cooler. Refer to AUXILIARY TRANSMISSION FLUID COOLER  in this article.
  2. If the fault is not visually evident, GO to SYMPTOM CHART - TRANSMISSION COOLING  or GO to SYMPTOM CHART - NVH .