LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2006 >> LS >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Tank And Lines >> Removal And Installation >> Fuel Transfer Pump >> Removal

Fuel Transfer Pump: Removal

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions can result in personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related components. Highly flammable mixtures are present and may be ignited. Failure to follow these instructions can result in personal injury.
  1. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY MOUNTING AND CABLES .
  3. Insert the special tool into the fuel tank filler pipe until it reaches the fuel tank spout.
    Fig 1: Identifying Special Tool
    G04691886Courtesy of FORD MOTOR CO.
  4. Attach the fuel storage tanker to the fuel drain hose and remove any residual fuel in the fuel tank filler pipe.
  5. Remove the rear seat bottom and any insulation padding covering the fuel transfer pump access cover. For additional information, refer to SEATING .
  6. Remove the fuel transfer pump access cover.
    Fig 2: Locating Fuel Pump Access Cover
    G04691887Courtesy of FORD MOTOR CO.
  7. Disconnect the electrical connector from the fuel transfer pump module.
    Fig 3: Locating Fuel Transfer Pump Module Electrical Connector
    G04691888Courtesy of FORD MOTOR CO.
  8. Loosen the right fuel tank support strap approximately one inch.
  9. Loosen the left fuel tank support strap approximately one inch.
  10. Using the special tool, remove the fuel transfer pump lock ring.
    Fig 4: Identifying Special Tool
    G04691889Courtesy of FORD MOTOR CO.
  11. Partially raise the fuel transfer pump and disconnect the internal fuel crossover tube quick connect couplings and remove the fuel transfer pump.
    • Remove and discard the fuel transfer pump O-ring seal.