Rear Seat Backrest - Third Row
- Remove the third row seat backrest. For additional information, refer to REAR SEAT - THIRD ROW .
- Disassemble the parts in the order indicated in the following illustration and table.
- To assemble, reverse the disassembly procedure.
- Remove the load floor from the seat backrest.
- Remove the screws.
- Rotate the rod 90 degrees and pull it out.
ITEM 2: LOAD FLOOR RODS DISASSEMBLY NOTE
- Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
ITEM 4: HEAD RESTRAINT SLEEVES DISASSEMBLY NOTE
NOTE:
The inboard and outboard head restraint sleeves are not interchangeable.
NOTE:
The head restraint sleeves incorporate an alignment tab that must face forward when installed.
- Separate the hook and loop fasteners.
ITEM 5: BACKREST TRIM COVER DISASSEMBLY NOTE
CAUTION:
Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat backrest foam pad.