Crankshaft End Play: Procedure
- Measure the crankshaft end play. Use a Dial Indicator Gauge with Holding Fixture to measure crankshaft end play.
- Position the crankshaft to the rear of the cylinder block.
- Zero the indicator.
- Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
- If crankshaft end play exceeds specifications, install a new crankshaft thrust washer or crankshaft thrust main bearing. For the procedure, refer to ENGINE - 4.6L AND 5.4L (2V)
for Expedition or ENGINE 5.4L (4V)
for Navigator.
Courtesy of FORD MOTOR CO.