LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2002 >> Navigator 4WD >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Power Mirror System >> System Tests >> Test C: Single Mirror Malfunction With Switch Logic (Without Memory)

Test C: Single Mirror Malfunction With Switch Logic (Without Memory)

  1. Turn ignition switch to LOCK position. Remove mirror control switch and disconnect harness connector. Test mirror control switch. See MIRROR CONTROL SWITCH  under COMPONENT TESTS. If mirror control switch is okay, go to next step. If mirror control switch is defective, replace as necessary. See MIRROR CONTROL SWITCH  under REMOVAL & INSTALLATION.
  2. Disconnect inoperative side mirror harness connector. Measure resistance between mirror control switch harness connector and inoperative side mirror harness connector as specified. See POWER MIRROR CIRCUIT IDENTIFICATION  table. If any resistance is more than 5 ohms, repair open in appropriate wire between mirror control switch and inoperative side mirror. See WIRING DIAGRAMS . If all resistances are 5 ohms or less, and mirror operates in only 3 directions, go to next step. If all resistances are 5 ohms or less, and mirror operates in only 2 directions, replace appropriate mirror and check system operation. See SIDE MIRROR ASSEMBLY  under REMOVAL & INSTALLATION.
    POWER MIRROR CIRCUIT IDENTIFICATION

    Application Wire Color
    Driver's Side Mirror
    Left & Right Red Wire
    Up & Down Dark Blue Wire
    (1) Yellow Wire
    Passenger's Side Mirror
    Left & Right Dark Green Wire
    Up & Down Violet Wire
    (1) Yellow Wire
    (1) Yellow wire is used as ground and power for bi-directional motors in mirrors. See WIRING DIAGRAMS .
  3. Measure resistance between ground and Dark Blue wire, Dark Green wire, Red wire and Violet wire at mirror control switch harness connector. If all resistances are more than 10 k/ohms, go to next step. If any resistance is 10 k/ohms or less, repair short to ground in appropriate wire between mirror control switch and appropriate mirror. See WIRING DIAGRAMS .
  4. Turn ignition switch to RUN position. Measure voltage between ground and Dark Blue wire, Dark Green wire, Red wire and Violet wire at mirror control switch harness connector. If voltage exists at any terminal, repair short to power in appropriate wire between mirror control switch and appropriate mirror. See WIRING DIAGRAMS . If voltage does not exist at any terminal, replace defective side mirror. See SIDE MIRROR ASSEMBLY  under REMOVAL & INSTALLATION.