LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2001 >> LS 3.0 S, Standard >> Repair and Diagnosis >> Body & Frame >> Power Windows >> System Tests >> Test D: All Windows Are Inoperative From Master Window Adjust Switch

Test D: All Windows Are Inoperative From Master Window Adjust Switch

  1. Turn ignition switch to LOCK position. Disconnect master window adjust switch 16-pin harness connector C504. Turn ignition switch to RUN position. Measure voltage between ground and master window adjust switch harness connector C504 terminal No. 9 (Yellow/Red wire). See Fig 1 . If voltage is 6 volts or more, go to next step. If voltage is less than 6 volts, go to step  3 .
  2. Turn ignition switch to LOCK position. Remove and test master window adjust switch. See MASTER WINDOW ADJUST SWITCH  under COMPONENT TESTS. If switch is okay, replace driver's door module. If switch is defective, replace master window adjust switch.
  3. Turn ignition switch to LOCK position. Disconnect Driver's Door Module (DDM) 26-pin harness connector C501d. DDM is located behind driver's door panel. Turn ignition switch to RUN position. Measure voltage between master window adjust switch harness connector C504 terminal No. 9 (Yellow/Red wire) and DDM harness connector C501d terminal No. 12 (Yellow wire). See Figure and Fig 1 . If resistance is less than 5 ohms, replace DDM. If resistance is 5 ohms or more, repair open in circuit between master window adjust switch and DDM. See WIRING DIAGRAMS  .
Fig 1: Identifying Master Window Adjust Switch Harness Connector C504 Terminals
G00012329Courtesy of FORD MOTOR CO.