LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> Navigator 4WD >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seat System >> System Tests >> Test R: Driver's Power Lumbar Inoperative

Test R: Driver's Power Lumbar Inoperative

CAUTION: On models equipped with side air bags, Air Bag Simulators (Restraint Diagnostic Tool 105-R0012) MUST be connected to all air bag floor connector. After diagnosing/repairing, restraint system diagnostic tool must be removed prior to operating vehicle.
WARNING: On models equipped with side air bags, system must be deactivated. To deactivate air bag system, disconnect negative battery cable and wait one minute.
  1. Disconnect driver's lumbar switch harness connector C319. Measure voltage of Dark Green wire at lumbar switch connector terminal No. 2. See Fig 1 . If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, repair open in Dark Green wire.
  2. Measure resistance between terminals No. 3 (Black wire) and No. 6 (Black wire) at lumbar switch connector. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Black wire(s).
  3. Connect driver's lumbar switch connector C319. Disconnect driver's lumbar motor harness connector C362. Measure voltage between Brown wire and Pink wire terminals at lumbar motor connector. Operate lumbar switch in both directions. If voltage is less than 10 volts, in both directions replace driver's lumbar motor. If voltage is greater than 10 volts, in both directions, go to next step.
  4. Disconnect driver's lumbar switch connector C319. Measure resistance between ground and terminal No. 7 (Pink wire) at driver's lumbar switch connector. Measure resistance between ground and terminal No. 1 (Brown wire) at driver's lumbar switch connector. If each resistance is greater than 10 k/ohms, go to next step. If each resistance is less than 10 k/ohms, repair short to ground in Pink wire or Brown wire.
  5. Measure resistance of Brown wire between lumbar motor connector and terminal No. 1 at driver's lumbar switch connector. Measure resistance of Pink wire between lumbar motor connector and terminal No. 7 at driver's lumbar switch connector. If each resistance is 5 ohms or less, replace driver's lumbar switch. If each resistance is greater than 5 ohms, repair open in Brown wire or Pink wire.
    Fig 1: Identifying Power Lumbar Switch Connector Terminals
    G00013591Courtesy of FORD MOTOR CO.