Test A: Power Seat Inoperative
CAUTION:
On models equipped with side air bags, Air Bag Simulators (Restraint Diagnostic Tool 105-R0012) MUST be connected to all air bag floor connector. After diagnosing/repairing, restraint system diagnostic tool must be removed prior to operating vehicle.
WARNING:
On models equipped with side air bags, system must be deactivated. To deactivate air bag system, disconnect negative battery cable and wait one minute.
NOTE:
For Navigator driver's seat, see B: POWER SEAT INOPERATIVE (NAVIGATOR ONLY)
.
- Disconnect seat control switch connector. See Fig 1 . Measure voltage of terminal No. 4 (Dark Green wire on driver's seat without memory; Black/White wire on passenger's seat) at seat control switch connector. If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, repair appropriate wire. See WIRING DIAGRAMS .
- Measure resistance between ground and terminal No. 8 (Black wire) at seat control switch connector. If resistance is less than 5 ohms, replace seat control switch. See SEAT CONTROL SWITCH under REMOVAL & INSTALLATION. If resistance is 5 ohms or more, repair open in Black wire.