LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> Navigator 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> System Tests >> Test C: Cruise Control System Does Not Disengage When Brakes Are Applied

Test C: Cruise Control System Does Not Disengage When Brakes Are Applied

  1. Check operation of stoplights. If stoplights operate properly, go to next step. If stoplights do not operate properly, repair stoplights as necessary. See EXTERIOR LIGHTS article.
  2. Turn ignition switch to LOCK position. Disconnect speed control servo harness connector C157. Measure voltage between terminals No. 4 (Red/Light Green wire) and No. 10 (Black wire) at speed control servo harness connector C157 while pressing brake pedal. See Figure . If battery voltage exists, go to next step. If battery voltage does not exist, repair open in Red/Light Green wire. See WIRING DIAGRAMS  .
  3. Disconnect Brake Pedal Position (BPP) switch harness connector C252. Measure voltage between terminals No. 9 (Black/Yellow wire) and No. 10 (Black wire) at harness connector C157 while depressing and releasing brake pedal. Voltage should be zero volts with brake pedal firmly depressed and battery voltage with brake pedal released. If voltage is as specified, replace speed control servo. See SPEED CONTROL SERVO  under REMOVAL & INSTALLATION. If voltage is not as specified, repair open or short to ground in Black/Yellow wire between brake pressure switch and speed control servo. See WIRING DIAGRAMS  .