LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> LS 3.0 S, Standard >> Repair and Diagnosis >> Body & Frame >> Power Seats >> System Tests >> Test G: Memory Seat Inoperative

Test G: Memory Seat Inoperative

WARNING: LS is equipped with driver's and passenger's side air bags. Before testing or repairing power seat system, disable air bag system. See AIR BAG RESTRAINT SYSTEMS - LS article. For any diagnostic or service to power seats equipped with side air bags, use Air Bag Simulators (418-133). Air bag simulators must be installed to air bag floor connector, and removed prior to operating vehicle.
NOTE: After any repairs are complete, ensure all component are properly installed and all harness connectors are connected properly and repeat data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM in appropriate MODULE COMMUNICATIONS NETWORK - LS article.
  1. Perform memory recall for power side view mirrors. If mirrors operate correctly, go to next step. If mirrors do not operate correctly, repair power mirrors. See POWER MIRRORS - LS article.
  2. Using NGS tester, perform Driver's Seat Module (DSM) self-test. If DTC B1342 was retrieved, clear DTCs, repeat DSM self-test. If DTC B1342 was retrieved again, replace DSM. See DRIVER'S SEAT MODULE  under REMOVAL & INSTALLATION. Calibrate driver's seat. See SEAT CALIBRATION  under DESCRIPTION & OPERATION. If no DTCs were retrieved, go to next step.
  3. Calibrate driver's seat. See SEAT CALIBRATION  under DESCRIPTION & OPERATION. If any DSM DTCs were retrieved while calibrating driver's seat, perform appropriate test. See DRIVER'S SEAT MODULE DTC INDEX  table under SELF-DIAGNOSTIC SYSTEM. If no DSM DTCs were retrieved while calibrating driver's seat, go to next step.
  4. Program new seat memory position for positions No. 1 and 2. Activate memory recall from memory switch. If memory recall operates correctly, power seat is operating correctly at this time. Verify customer concern. If memory recall does not operate correctly, replace DSM. See DRIVER'S SEAT MODULE  under REMOVAL & INSTALLATION. Calibrate driver's seat. See SEAT CALIBRATION  under DESCRIPTION & OPERATION, then go to next step.
  5. Program new seat memory position for positions No. 1 and 2. Activate memory recall from remote keyless entry transmitter. If memory recall operates correctly, power seat is operating correctly at this time. Verify customer concern. If memory recall does not operate correctly, perform Driver's Door Module (DDM) and DSM self-test using NGS tester, then perform appropriate test. See appropriate DTC INDEX table under SELF-DIAGNOSTIC SYSTEM  .