DTC C1145: Right Front Sensor Input Circuit Failure
- Disconnect right front sensor connector. Using DVOM, measure resistance between right front sensor terminals. If resistance is 2100-3300 ohms (1998 models) or 1800-3000 ohms (1999 models), go to next step. If resistance is not as specified, replace right front sensor.
- Using DVOM, measure resistance between right front sensor terminal No. 1 (Yellow/Black wire) and ground. See WIRING DIAGRAMS . If resistance is greater than 10,000 ohms, go to next step. If resistance is less than 10,000 ohms, replace right front sensor.
- Reconnect right front sensor connector. Disconnect 25-pin ABS control module connector. Install EEC-IV 60-pin Breakout Box (014-00322). Using DVOM, measure voltage between breakout box terminals No. 3 and 18. If resistance is 2100-3300 ohms (1998 models), or 1800-3000 ohms (1999 models), go to next step. If resistance is not as specified, repair open or short to ground in Yellow/Red wire or Yellow/Black wire between right front sensor and ABS control module, or repair short between Yellow/Red wire and Yellow/Black wire.
- Using DVOM, measure resistance between breakout box terminals No. 3 and 8. If resistance is greater than 10,000 ohms, go to step 6. If resistance is less than 10,000 ohms, go to next step.
- Disconnect right front sensor connector. Using DVOM, measure resistance between breakout box terminals No. 3 and 8. If resistance is greater than 10,000 ohms, repair Yellow/Black wire between right front sensor and ABS control module. If resistance is less than 10,000 ohms, repair Yellow/Red wire between right front sensor and ABS control module.
- Reconnect all previously disconnected connectors. Using NGS tester, clear DTCs. Turn ignition off, and then on. Using NGS tester, retrieve ABS DTCs. If DTC C1145 is set, replace ABS control module. If DTC C1145 is not set, check connections for an intermittent problem such as corrosion, damage, pushed-out, or loose connections. Repair as necessary.