Test E: Reverse Tilt Feature Inoperative
NOTE:
Many test steps refer to various connectors. To identify connectors, use illustrations. See Figure
-Figure
.
- Operate both mirror through all positions. If both mirrors operate properly, go to next step. If both mirrors do not operate properly, repair mirrors as necessary. See SYMPTOM CHART under SYSTEM TESTS.
- Turn ignition switch to RUN position. Select REVERSE MIRRORS feature on message center. If REVERSE MIRROR feature is enabled, go to next step. If REVERSE MIRROR feature is not enabled, enable feature and inform customer of proper operation.
- Turn ignition switch to RUN position. Set parking brake. Place transmission in Reverse. Wait 15 seconds then place transmission in Park. If mirrors do not move down when transmission is in Reverse and return to previous position when transmission is returned to Park, go to next step. If mirrors move down when transmission is in Reverse and return to previous position when transmission is returned to Park, system is okay at this time.
- Connect New Generation Star (NGS) tester to data link connector. Perform Driver Seat Module (DSM) self-test. If no DSM DTCs exist, replace DSM. If any DSM DTCs exist, perform appropriate test. See TILT FEATURE TEST table.
TILT FEATURE TEST
| DTC | Go To | ||
|---|---|---|---|
| B1667 & B2324 | TEST D | ||
| B1667 & B2327 | TEST D | ||
| B1669 & B2327 | TEST D | ||
| B1669 & B2319 | TEST D | ||
| U1059 | (1) | ||
|
|||