Alarm Triggering Verification
- With driver's window down, arm system. Unlock and open driver's door from inside vehicle. If alarm triggers and cycles, go to step 2). If alarm does not trigger, replace control module. If alarm triggers and does not cycle but is on steady, replace control module and retest system.
- Horns should sound on and off. If horns sound, go to step 3). If horns are silent, check horn relay, horns or circuit No. 1 (Dark Blue) wire.
- Tail and parking lights should flash on and off. If lights flash on and off, go to step 4). If lights stay off, check circuit No. 14 (Brown) wire and retest system.
- Low beam headlights should flash on and off. If low beam headlights flash on and off, go to step 5). If low beam headlights stay off, check circuit No. 13 (Red/Black) wire.
- Attempt to start vehicle. If vehicle will not start, alarm triggering sequence is okay. If vehicle starts, go to step 6).
- Disconnect alarm module from wiring harness and attempt to start vehicle. If vehicle starts, go to step 7). If vehicle will not start, replace control module and retest.
- Check for 1000 ohms or more between pins No. 12 and 13 of control module harness connector. If reading is more than 1000 ohms, replace control module and retest. If reading is less than 50 ohms, check circuits No. 325 (Dark Blue/Orange) wire and No. 33 (White/Pink) wire.