Removal [12/2017 - 09/2018]: Procedure
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [12/2017 - 09/2018]
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [12/2017 - 09/2018]
- REMOVE BATTERY CARRIER CATCH BRACKET SUB-ASSEMBLY
Refer to REMOVAL [12/2017 - 09/2018]
- REMOVE REAR ACTIVE STABILIZER CONTROL ECU
- Disconnect the rear active stabilizer control actuator connector labeled A.
- Disconnect the rear active stabilizer control actuator connector labeled B.
- Release the lever's lock. (*1)
- Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
- Disconnect the rear active stabilizer control actuator connector. (*3)NOTE:
When disconnecting the actuator connector, do not apply excessive force to the wire harness.
- Remove the 3 nuts and rear active stabilizer control ECU.
- Disconnect the rear active stabilizer control ECU connector.
- Release the lever's lock. (*1)
- Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
- Disconnect the rear active stabilizer control ECU connector. (*3)NOTE:
When disconnecting the ECU connector, do not apply excessive force to the wire harness.
- Disconnect the shielded ground wire connector.
- Disconnect the rear active stabilizer control actuator connector labeled A.