LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Convertible >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System - Service Information (Convertible) >> Brake Control Power Supply >> Removal [07/2020 - 05/2023] >> Procedure

Removal [07/2020 - 05/2023]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to PRECAUTION [07/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to REMOVAL [07/2020 - 05/2023]

  3. REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER 

    Refer to DISASSEMBLY [07/2020 - 10/2022] , or refer to DISASSEMBLY [10/2022 - 05/2023]

  4. REMOVE NO. 1 DECK BOARD BRACKET LH 
    1. Remove the bolt, nut and No. 1 deck board bracket LH.
      GTY804583Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE FUEL PUMP CONTROL ECU BRACKET 
    WARNING:

    After removing the brake control power supply with bracket assembly from the vehicle, there may be an electrical charge left in the internal capacitor. If planning to inspect the inside of the brake control power supply with bracket assembly, leave it as is for more than 24 hours (to discharge it) after removing it from the vehicle. Then, perform the inspection.

    1. Disconnect the brake control power supply connector.
      GTY833717Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the 2 fuel pump control ECU connectors.
    3. Detach the clamp
      GTY833716Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 bolts, nut and fuel pump control ECU bracket from the vehicle body.
      GTY821662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE BRAKE CONTROL POWER SUPPLY WITH BRACKET ASSEMBLY 
    1. Remove the 2 nuts and brake control power supply with bracket assembly from the fuel pump control ECU bracket.
      GTY804567Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002