On-Vehicle Inspection [06/2018 - ]: Procedure
- INSPECT DEF RELAY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 4 Auxiliary battery voltage applied between terminals 1 and 2 10 kΩ or higher 3 - 4 Auxiliary battery voltage not applied between terminals Below 1 Ω 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω 3 - 5 Auxiliary battery voltage not applied between terminals 10 kΩ or higher 4 - 5 Always 10 kΩ or higher If the result is not as specified, replace the DEF relay.
- Measure the resistance according to the value(s) in the table below.
- INSPECT DEICER RELAY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω 3 - 5 Auxiliary battery voltage not applied between terminals 10 kΩ or higher If the result is not as specified, replace the deicer relay.
- Measure the resistance according to the value(s) in the table below.
- INSPECT HWD RELAY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω 3 - 5 Auxiliary battery voltage not applied between terminals 10 kΩ or higher If the result is not as specified, replace the HWD relay.
- Measure the resistance according to the value(s) in the table below.