LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> NX 300h Base >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System (Service Information) >> Fuel Pump >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL FUEL SUCTION TUBE ASSEMBLY 
    1. Install a new gasket onto the fuel suction tube assembly.
    2. With the paint mark facing the top of the vehicle, connect the fuel hose to the fuel suction tube assembly and secure the hose with the clamp.
      GTY515182Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Fuel Hose
      *a Paint Mark
      *b Top of Vehicle
    3. Install the fuel suction tube assembly to the fuel tank assembly.
      NOTE:

      Be careful not to damage the fuel suction tube assembly.

  2. INSTALL FUEL TANK VENT TUBE SET PLATE 
    1. Install the fuel tank vent tube set plate with the 8 bolts.

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

  3. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY 
    1. Connect the fuel tank main tube sub-assembly to the fuel suction plate sub-assembly, then install the tube joint clip.
      GTY515937Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      GTY511876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Fuel Tube Joint
      *2 Fuel Tank Main Tube Sub-assembly
      *3 Tube Joint Clip
      *4 O-Ring
      *a Collar
      *b CORRECT
      *c INCORRECT
      • Check that there are no scratches or foreign objects on the connecting parts.
      • Check that the fuel tube joint is inserted securely.
      • Make sure that the fuel joint clip is above the flange of the fuel tank main tube sub-assembly.
      • After installing the tube joint clip, make sure that the fuel tank main tube sub-assembly cannot be pulled out.
      • Be careful not to damage the tube joint clip. If the tube joint clip is damaged, replace it.
  4. INSTALL FUEL TANK ASSEMBLY 

    Refer to INSTALLATION [10/2014 - 05/2019] Refer to INSTALLATION [05/2019 - ]