LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 Base >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case - Service Information >> Transfer Valve Body Assembly >> Inspection [04/2013 - ] >> Procedure

Inspection [04/2013 - ]: Procedure

  1. INSPECT TRANSFER CONTROL SOLENOID ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY461696Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Transfer Control Solenoid Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 5.0 to 5.6 Ω

      If the resistance is not within the specified range, replace the transfer control solenoid assembly.

    2. Connect a positive (+) lead with a 21 W bulb to terminal 1 and a negative (-) lead to terminal 2 of the transfer control solenoid assembly connector, and then check the operation of the solenoid.

      OK

      The solenoid operates and an operating sound is heard.

      If the resistance is not within the specified range, replace the transfer control solenoid assembly.