Removal [07/2015 - ]: Procedure
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Refer to PRECAUTION [07/2015 - ] ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [07/2015 - ] ).
- REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
(Refer to REMOVAL [07/2015 - ] )
- REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
(Refer to REMOVAL [07/2015 - ] )
- REMOVE FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 4
- REMOVE COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 5
- REMOVE FRONT DOOR OPENING TRIM COVER LH
Refer to PROCEDURE - Step 6
- REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 18
- DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 19
- REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 20
- REMOVE SWITCH BASE
Refer to PROCEDURE - Step 24
- REMOVE ENGINE SWITCH