LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> SC 430 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> Dismounting/Mounting Procedures >> Tire Pressure Sensor >> Removal

Tire Pressure Sensor: Removal

  1. When replacing a wheel or tire, tire pressure sensors must be set up in one of the following ways:
    • Remove the sensor from the old wheel and install it to the new wheel.
    • Keep the same wheel with tire pressure sensor, and replace only the tire.
    • Use a new wheel and sensor (the new sensor must be registered after installation).
  2. Remove wheel. Remove the valve core and cap, and release air from the tire. See Fig 1.
  3. After ensuring that air is sufficiently released, remove the nut, washer and outer grommet that is used to hold the tire pressure monitor valve sub-assembly and drop the sensor inside the tire.
    NOTE: Keep the removed cap, valve core, nut and washer.
  4. After dropping the tire pressure monitor valve sub-assembly into the tire, disengage the bead using the shoe of the tire remover. See Fig 2.
    NOTE: Be careful not to damage the tire pressure monitor valve sub-assembly due to interference between the sensor and tire bead.
  5. Remove the bead on the upper side in the usual operation.
  6. Take out the sensor from the tire, and remove the bead on the lower side as in usual operation.
  7. Remove the inner grommet from the tire pressure monitor valve sub-assembly.
    NOTE: Check that no cracks or damage is identified on the grommet. If so, replace the grommet together with the washer and nut.
Fig 1: Exploded View Of Tire Pressure Monitor Valve
G00251665Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Disengaging Bead Using Tire Remover
G00225401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002