LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> SC 430 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Service Information) >> Transmission Wire >> Removal >> Removal

Transmission Wire: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. DRAIN AUTOMATIC TRANSMISSION FLUID 
    1. Remove the drain plug and gasket, and drain the ATF.
    2. Install a new gasket and the drain plug.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

  3. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY 
    Fig 1: Locating Exhaust Pipe Support Bracket Sub-Assembly Bolts
    GTY128170Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 4 bolts, 2 nuts and bracket.
  4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY 
    NOTE:

    Some fluid will remain in the oil pan.

    1. Remove the 20 bolts, oil pan and gasket.
      Fig 2: Locating Oil Pan Bolts
      GTY103695Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 magnets from the oil pan.
      Fig 3: Identifying Oil Pan Magnet
      GTY144494Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Examine the particles in the pan.
      1. Collect any steel chips with the removed magnets.

        Carefully look at the foreign objects and particles in the pan and on the magnets to guess the type of wear which might be found in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY 
    1. Remove the 4 bolts and oil strainer.
      Fig 4: Locating Oil Strainer Bolts
      GTY102813Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Be careful as some fluid will come out of the oil strainer.

    2. Remove the O-ring from the oil strainer.
      Fig 5: Identifying Oil Strainer O-Ring
      GTY101294Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE TRANSMISSION WIRE 
    1. Remove the bolt, lock plate and ATF temperature sensor.
      Fig 6: Locating ATF Temperature Sensor Locking Plate Bolt
      GTY106498Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and disconnect the 2 clamps.
      Fig 7: Identifying Clamps
      GTY104201Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the 9 connectors from the solenoid valves.
      Fig 8: Locating Solenoid Valves Connectors
      GTY104237Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the transmission wire connector.
    5. Remove the bolt and pull out the transmission wire.
      Fig 9: Locating Transmission Wire Connector Bolt
      GTY155297Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the O-ring from the transmission wire.
      Fig 10: Identifying Transmission Wire Harness O-Ring
      GTY106495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002