LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> SC 430 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Service Information) >> Park / Neutral Position Switch >> Installation (To 10/2008) >> Installation

Installation (To 10/2008): Installation

  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Install the park/neutral position switch to the automatic transmission.
    2. Temporarily install the bolt.
      Fig 1: Locating Park/Neutral Position Switch Bolt
      GTY106464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install a new lock washer with the nut.
      Fig 2: Locating Lock Nut And Lock Washer
      GTY104084Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 6.9 N*m (70 kgf*cm, 62 in.*lbf) 

    4. Temporarily install the control shaft lever.
      Fig 3: Identifying Control Shaft Lever
      GTY114278Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
      Fig 4: Turning Control Shaft Lever
      GTY102740Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the transmission control shaft lever.
    7. Align the neutral basic line with the switch groove, and tighten the adjusting bolt.
      Fig 5: Identifying Neutral Basic Line, Groove And Bolt
      GTY149426Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

    8. Using a screwdriver, bend the tabs of the lock washer.

      HINT: 

      Bend at least 2 washer tabs.

      Fig 6: Bending Tabs Of Lock Washer
      GTY123877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Install the transmission control shaft lever RH with the nut.
      Fig 7: Identifying Control Shaft Lever
      GTY114278Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf) 

    10. Connect the park/neutral position switch connector.
      Fig 8: Identifying Perk/Neutral Position Switch Connector
      GTY114274Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  See step  2
  3. INSTALL CENTER EXHAUST PIPE ASSEMBLY 
    1. Install the center exhaust pipe. Refer to INSTALLATION .
  4. INSTALL FRONT EXHAUST PIPE ASSEMBLY 
    1. Install the front exhaust pipe. Refer to INSTALLATION .
  5. INSTALL FRONT FLOOR CENTER BRACE 
    1. Install the floor brace with the 4 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

  6. CONNECT HEATED OXYGEN SENSOR (for Sensor 2) 
    1. Connect the sensor. Refer to INSTALLATION .
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  8. ADJUST SHIFT LEVER POSITION  See step  1
  9. INSPECT SHIFT LEVER POSITION  See step  1
  10. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY  See step  1
  11. PERFORM INITIALIZATION 
    1. Perform initialization. Refer to INITIALIZATION .
      NOTE:

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.