LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> IS 350 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Power Door Lock Control System (Diagnostic Codes & Circuit Tests) >> Power Door Lock Control System >> Door Control Switch Circuit >> Procedure

Door Control Switch Circuit: Procedure

  1. READ VALUE USING DATA LIST (FRONT PASSENGER SIDE DOOR CONTROL SWITCH ASSEMBLY) 
    1. Check the Data List to ensure proper function of the front passenger door lock switch.
      MAIN BODY ECU:

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D/L SW-Lock Front passenger side door control switch lock signal
      /ON or OFF
      ON: Door control switch is pushed to LOCK position
      OFF: Door control switch is not pushed to LOCK position
      -
      D/L SW-Unlock Front passenger side door control switch unlock signal
      /ON or OFF
      ON: Door control switch is pushed to UNLOCK position
      OFF: Door control switch is not pushed to UNLOCK position
      -

      OK

      The display is as specified in the normal condition column.

    NG → See step   2 

    OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

  2. INSPECT DOOR CONTROL SWITCH ASSEMBLY 
    1. Remove the door control switch assembly.
      Fig 1: Inspecting Door Control Switch Assembly
      GTY128900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance

      Tester Connection Condition Specified Condition
      2 - 3 Lock Below 1 Ω
      2 - 3
      3 - 4
      OFF (Free) 10 kΩ or higher
      3 - 4 Unlock Below 1 Ω

    NG → REPLACE DOOR CONTROL SWITCH ASSEMBLY 

    OK: Go to next step 

  3. CHECK WIRE HARNESS (DOOR CONTROL SWITCH ASSEMBLY - MAIN BODY ECU RH) 
    1. Disconnect the door control switch assembly connector.
      Fig 2: Identifying L16 Door Control Switch Assembly Connector
      GTY143788Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the ECU (cowl side J/B RH) connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance

      Tester Connection
      (Symbols)
      Condition Specified Condition
      L16-2 (L) - RJ-7 Always Below 1 Ω
      L16-4 (UL) - RJ-10 Always Below 1 Ω
      L16-3 (E) - Body ground Always Below 1 Ω
      RJ-7 - Body ground Always 10 kΩ or higher
      RJ-10 - Body ground Always 10 kΩ or higher

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → REPLACE MAIN BODY ECU RH (COWL SIDE J/B RH)